TANIM
It is a thermal insulation spray coating that provides energy saving in industrial pipes, based on specially modified pure acrylic resin and made up of vacuumed natural silica spheres that have been subjected to special processes.
FEATURES
It is water-based, provides heat insulation and is fire resistant.
It is used for energy saving purposes in hot-cold transfer pipes of all kinds of ships, oil and industrial facilities.
Gloss: Matte
Color: Any color can be produced.
Solid Matter: 70±2% (by weight)
Density: 0.80 gr/cm³
Application: Airless spraying
Spray pressure: 40 Bar / 580 psi
Nozzle Diameter: 0.021”- 0.027”
Flash Point: Non-flammable
Single Layer Dry Film Thickness: 0.800-1 mm
CONSUMPTION:
The consumption is 0.800-1 kg/m² depending on the type, absorbency and structure of the surface to be applied. A controlled sample study should be carried out for the exact consumption.
DRYING TIME (at 20°C, 65% HR):
Touch dry: 2-4 hours, Final dry: 24 hours (drying time may be longer at higher relative humidity and lower temperatures).
It can be stored for 3 years in its unopened packaging, in a cool (+5°C to +30°C) and dry place, protected from frost and direct sunlight. Close the lid of the packaging immediately after use in an airtight manner.
R 43: May cause sensitization by skin contact. S 2: Keep out of reach of children. S 23: Do not breathe vapour. S 24/25: Avoid contact with eyes and skin. S 37: Wear suitable gloves. S 46: In case of swallowing, seek medical advice immediately and show the container or label. S 56: Dispose of this substance and its container to hazardous or special waste collection point.
Application should be made on surfaces that are cleaned from all kinds of oil, dirt, rust and dust and have had their surfaces repaired. Isothermal Isopipe Coating application consists of a single layer application. The material should be mixed homogeneously with a mixer or mechanical mixer before the coating application. It is ready to use, no thinning should be done. Application is made by saturating the surface in a single layer with an airless spraying machine. The surface temperature should be between +5 and +30 during application. Heat transfer should be made from the pipes at least 12 hours after the application.